![Home](_derived/home_cmp_network010_vbtn.gif)
![FF02](_derived/ff02.htm_cmp_network010_vbtn.gif)
![FF01 - SU](_derived/ff01.htm_cmp_network010_vbtn_p.gif)
|
|
This motor was my first attempt at the
elusive 54mm Single Use motor. It was a total of 16 inches long,
and used an Aerotech Medusa nozzle, drilled to 0.59 inch. Since I
did not have any casting tubes, I made this a monolithic grain, so it
was VERY progressive. Our recording altimeter does show a very
progressive curve. This picture is a 10lb PML Eclipse built
by Erik Hall flying on this motor. This pink flame is VERY
evident.
![](ff01_small.jpg)
|
|